02381-987 98 94
Produktdetails
Easy Angle 6.5 Inch
Art.Nr.: EZ8823759
für Half Square Triangles, 2 Dreiecke aus einem Quadrat geschnitten.
Easy Angle 6.5 Inch
by Sharon Hultgren
- Schneiden Sie Dreiecke, Quadrate oder Attic Window-Formen alle aus dem gleichen Streifen Stoff
- Geteilte Dreiecke in der Größe von 1/2 inch bis 6 inch (fertige Größe)
- Ideal für Rollschneider
- inklusiv 1/4 inch Nahtzugabe
| Using the Easy Angle Before cutting strips, fold your fabric once parallel to the selvedge edges, with selvedge edges together. Then fold again in the same direction. Trim along one side of the folded fabric perpendicular to the selvedge edge to square it up. Determine the finished height of your triangles or the finished side of your triangle square (two half-square triangles sewn together to form a square) and add 1/2" to get the needed width of your strips (which will then include 1/4" seam allowances. Use an acrylic ruler to cut strips this wide. To cut triangles so that they are ready to sew together to make squares, place two strips right sides together and cut them at the same time. The fabric from each of the strips will make up one triangle in the square. | |
 |
Trim the end of the strip(s) to square them up. |
 |
Line up the bottom of the tool along the edge of the strip(s) and slide it along the strip(s) until the end of the strip(s) fill the triangle area shown for the required size. The number corresponding to the strip width should be in the upper corner of the strip (2-1/2" here). |
 |
If you have two strips laying right sides together, each time you cut you will get two triangles ready to sew to make squares. After sewing, press them open. After cutting, flip the tool over its long side (the hypotenuse), line up the edge of the strip(s) with that edge, and the black triangle top of the tool below the strip as shown. Cut along the edge perpendicular to the strip. Continue with these two cutting steps for additional triangles. |
 |
To cut squares (and rectangles), cut strips as wide as the unfinished square (rectangle) width. Then line up the edge of the tool with the top of the squared off strip as shown and slide the tool along the strip until the end of the strip lines up with the square (rectangle) length. Cut perpendicular to the strip. |
| These steps are the same for easy angle 6-1/2" and 10-1/2". | |
Einen Kommentar schreiben
Sie müssen angemeldet sein, um einen Kommentar schreiben zu können.
- Margaret schreibt:
- Ein Superteil...für die Streifenbreite brauche ich nur die gewünschte Quadratgröße plus NZG zu rechnen...die Streifen, die nötig sind, um Quadrate zu scheiden sind also schmaler als bei anderen Methoden....und es gibt keine Verschnitt. An einer Seite des Dreiecks wird die kleien spitze gleich weggelassen( trimming), was das Anlegen an andere Patchworkteile erleichtert!
Zuletzt angesehene Produkte
Lineal aus Acryl für den Block Drunkards Path
